AbiSee Eye-Pal Ace Plus User Manual download pdf (Page 10)

Then scroll to and select System Settings. Finally, scroll to and select Shut Down.

Checking the Battery Charge Status

To quickly check the battery status, press the round Center Daisy Button. An

announcement will tell which menu screen you are in, the battery status and whether

or not you are connected to a Network.

The battery status is also given in the Settings sub-menu under Status. To get to the

Status menu from the Main Menu, scroll to and select Settings. Then scroll to and

select Status. (The percentage of available battery charge is announced and also

displayed on the screen) “100%” means a fully charged battery. If the charge is below

15%, it is time to recharge. The Ace Plus can be used while it is being charged.

Charging the Battery

Important: Before the first use, the Ace Plus’s battery needs to be charged to full

capacity which can take up to four hours. To charge it, use the power supply and

power cord provided as follows: First connect the power cord end with the small prong

into the port at the end of the rectangular part of the power supply. Next, plug the

power supply cord into the power supply port on the Ace Plus. Finally, plug the power

cord into a power outlet.

Do not use the Ace Plus while it is being charged for the first time. Later on, the device

can be used while it is being charged. In general, charging a depleted Ace Plus battery

to full capacity takes approximately four hours. A fully charged Ace Plus battery lasts

for about five hours of continued use.

For safety reasons, only the adapter supplied by ABiSee, Inc. for the Ace Plus should

be used to charge the Ace Plus device.

Battery Replacement

When the battery has reached the end of its rechargeable life, a replacement can be

ordered either from the dealer who sold you the device or directly from ABiSee. On the

lower back side of the device, there is a battery compartment with a cover that is

attached by four small screws. To install the replacement battery, unscrew the screws,

and remove the cover and battery. Position the new battery like the original, replace it

and tighten the cover.

Internet Connection

The Ace Plus offers all the features of the standard Ace device (which are described in

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

No comments

AbiSee Eye-Pal Ace Plus User Manual Page 10